HS System Filler 4-1

Information: Irritating to eyes and skin. Keep away from sources of ignition. No smoking during usage. Do not breath vapors. Wear suitable equipment if ventilation is not sufficient.

Quick info

Description

Information: Irritating to eyes and skin. Keep away from sources of ignition. No smoking during usage. Do not breath vapors. Wear suitable equipment if ventilation is not sufficient.

 

Warning: before using carefully read health and safety information on label.

 

Working Process: 4: 1 HS Priming System
With Standox Hardeners

(05-15, 15-25, 20-30, 25-40, 30-45)

POT life 60-90 min/68 F(20 c)

If necessary, add up to 10% Standox 2k Thinner.

24-26 s/DIN 4 mm/68 F (20C)

1.5-1.8 mm

2-3 coats = up to 8.0 mil (200 micron)

Flash 5-10 minutes between coats

Please refer to gun manufacturer and local legislation for proper spray pressure recommendations.

1.4-1.8 mm

2-3 coats = up to 8.0 mil (200 micron)

Flash off 5-15 min/68 F(20 C), then

Please refer to gun manufacturer and local legislation for proper spray pressure recommendations.

Air dry 3 hours @80 F(27 C)or

Flash off 5-15 min/68 F (20C), then

Bake 30 min 140 F(60 c) panel temperature

Short wave 12-15 min

Medium wave 18-22 min

(see painting system S9)

For higher film builds overnight dry.

Orbital sand P400-P500

Wet Sand P600-P800

Standocryl 2k Paints or

Standox Basecoat / Standoblue Basecoat with Standocryl 2k Clears

Product Status: Available

Reviews

There are no reviews yet.

Be the first to review “HS System Filler 4-1”

Your email address will not be published.